#
# contributed by Bob van Loosen <loosenN0SPAM@xs4all.nl>
#                               (remove N0SPAM)
#
# This is the config file for the Onkyo TX-L5 receiver.
# The Remote interactive input/output can be
# hooked up to the serial port like this:
#
#                     +----|<|-----------------o DTR  
#                     |    D1 (1N4148)
#           R2 (10k) | | 
#                    | |
#                     |
# RI phone jack  +----+-----------------+------o DCD
# (mono, 3.5mm) /     |                 |
#          ____/     | | R1 (10k) +-|>|-+
#         /   /\     | |	  | D2 (5V1 zenerdiode)
#        (  ()  )     |           |
#         \____/------+-----------+------------o GND
#
#
# The remote interactive connection is an input
# and a pnp open collector output.
# With this schematic you can both send and
# receive over the same wire.
# If sending doesn't work try decreasing the value
# of R2 (look at the signal with a scope
# if you have one).
# So far I have only discovered the values of
# setting the MD, DVD and HD inputs.
# Once I have discovered the rest of the values
# this file will be updated.
#
# I have also discovered a reset value and some
# test modes.
# DO NOT TRY THESE!!!
# When I tried these the s/pdif inputs stopped
# working and I had to reset the amp by holding
# the subwoofer mode button and pressing the
# standby/on button.
#
# So here they are in decimal format:

#1056	reset
#1057	TEST- 1 -00
#1058	TEST- 2 -00
#1059	TEST- 3 -00
#1060	TEST- 4 -00	test tone couple 100 hertz
#1061	TEST- 4 -01	test tone 30 hertz or so
#1062	TEST- 4 -02
#1063	TEST- 4 -03	test tone couple 100 hertz
#1064	TEST- 4 -04	test tone couple 1000 hertz hurts your ears
#1065	TEST- 4 -05	test tone couple 1000 hertz hurts your ears
#1066	TEST- 4 -06	test tone couple 1000 hertz hurts your ears
#1067	TEST- 4 -07	test tone couple 1000 hertz hurts your ears
#1068	TEST- 4 -08	test tone couple 1000 hertz hurts your ears
#1069	TEST- 4 -09	test tone couple 1000 hertz hurts your ears
#1070	TEST- 4 -00	test tone couple 100 hertz
#1071	TEST- 4 - 10	test tone couple 100 hertz cycles through the test modes


begin remote

  name  Onkyo_TX-L5
  bits           12
  flags SPACE_ENC|CONST_LENGTH
  eps            30
  aeps          100

  header       2987   975
  one          1005  1967
  zero         1005   976
  ptrail       1005
  gap          108026
  toggle_bit      0


      begin codes
	play			0x71B
	stop			0x71C
	pause			0x71F
	fast_forward		0x70C
	fast_rewind		0x70D
	next_track		0x71D
	previous_track		0x71E
	return			0x709
	setup			0x74D
	top_menu		0x74E
	menu			0x74F
	enter			0x708
	up			0x750
	down			0x751
	left			0x752
	right			0x753

	md_play			0x81B
	md_stop			0x81C
	md_pause		0x81F
	md_rewind		0x801
	md_fast_forward		0x800
	md_next_track		0x81D
	md_previous_track	0x81E

	set_md			0x030
	set_dvd			0x120
	set_hd			0x170
      end codes

end remote